Building Priming
Subsurface priming device intended for interior and exterior construction works.

The priming is made on the basis of acryl-styrene copolymer dispersion and is intended for priming plaster, moisture-absorbing and porous surfaces: concrete-tracing plaster, gypsum and gypsum-paperboard, sawdust slabs, wooden surfaces. It improves the cohesion between lute, paint, wallpapers and processed surfaces. Because of the deep preparation into a processed surface, the priming does not create an airtight and watertight film. The priming is also intended for exterior construction works. Primate surfaces are resistant to alkali and moisture influence and protect house facades from the damaging effect of the atmosphere.

The priming is made from the certified by ISO and their producer high quality raw materials we import ourselves from Germany.

Our produced gods are also certified by SPSC (Building Production Certification Centre).

REGULATION ON THE USE

Base preparations: the surfaces to prime have to be dry, clean, without greasy stains; the priming has to be thoroughly stirred; then coat a prepared surface with one layer of priming- very porous and free-flowing surfaces have to be primed twice. The second coating has to be done only after the first layer has fully dried out. For interior construction works it is recommended to dissolve the priming in water at the ratio of 1:1. The surface coated with one layer of priming at a temperature of 20ºC dries in an hour. Subsequent works have to be done twenty-four hours later. The priming yield is 1ltr/10-15 m².
Application time: 6 months from the date of manufacture.

After an order has been placed via telephone or fax, in Vilnius and Klaipeda we deliver production by the company's transport to location or warehouse.